NordicTrack a2550 pro warranty Console Wire Assembly Tie

9.Set the console assembly face down on a soft surface to avoid scratching the console. Identify the Right Handrail (79). Hold the Right Handrail near the console assembly. Route the console wire through the large holes in the top and bottom of the Right Handrail.

Set the Right Handrail (79) on the Console Frame (81). Start a 1/4" x 1/2" Patch Bolt (8) with a 1/4" Star Washer (12) into the Right Handrail. Then, start two 5/16" x 1 1/2" Patch Bolts (4) with two 5/16" Star Washers (9) into the Right Handrail. Make sure the console wire is not pinched. Start all three Patch Bolts, and then tighten them.

Attach the Left Handrail (not shown) as de- scribed above. Note: There is not a wire on the left side.

10.With the help of a second person, hold the con- sole assembly near the Right Upright (83) and the Left Upright (not shown).

Connect the Upright Wire (85) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-

NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire.

9		8	Console
79	12			4
			Wire
				9
Console
Assembly				81

10	Console
	Assembly
	Console
	Wire	85
Wire
			Console
	Tie	83
			Wire
			85

11