2.Press a 50mm x 100mm Cap (23) into the Right Frame (3). Insert two M10 x 116mm Carriage Bolts (53) up into the Right Frame. Note: The
Right Frame has a short weldment in the indi- cated location; the other side has a long weld- ment.
Attach the Right Frame (3) to the Base Frame (1) with two M10 x 70mm Button Head Bolts (52), two M10 Washers (62), and two M10 Nylon Locknuts (64). Do not tighten the Locknuts yet.
Attach the Left Frame (not shown) to the Base Frame (1) in the same manner.
Orient an Upright (4) as shown. Attach the Upright to the Right Frame (3) with the two M10 x 116mm Carriage Bolts (53) and two M10 Nylon Locknuts (64). Do not tighten the Locknuts yet.
Attach the other Upright (not shown) to the Left Frame (not shown) in the same manner.
3.Make sure there is a 60mm Square Cap (22) in the top of the Center Upright (6).
Orient the Center Upright (6) so that the letters are on the indicated side. Attach the Center Upright to the Base Frame (1) with two M10 x 152mm Button Head Bolts (54), two M10 Washers (62), and an M10 Nylon Locknut (64).
Make sure the Washers and Locknut are on the lower Bolt. Do not tighten the Locknut yet.
2 |
|
|
High |
|
|
Side |
|
|
Numbers |
|
|
4 |
|
|
| 64 |
|
64 | 62 | 23 |
| ||
3 |
| 52 |
|
| |
| 1 |
|
| 52 |
|
| 53 |
|
| Short |
|
| Weldment |
|
3 |
|
|
| 22 |
|
Letters on |
|
|
this side |
|
|
| 6 |
|
64 | 1 |
|
62 |
| |
| 62 |
|
|
| 54 |
6
