3. Attach the Front Leg (12) to the Bench Frame (3) with
two M10 x 70mm Bolts (23), a Support Plate (10), and
two M10 Nylon Locknuts (6).
3
12
6
6
3
10
23
6
¥Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
¥Tighten all parts as you assemble them, unless
instructed to do otherwise. For help identifying
small parts, use the PARTIDENTIFICATION
CHART on page 5.
¥As you assemble the weight bench, make sure
that all parts are turned as shown in the drawings.
¥ Assembly requires:
two adjustable wrenches
a rubber mallet
a standard screwdriver
a phillips screwdriver
lubricant, such as grease or petroleum jelly.
Assembly may be more convenient with a socket
set or a set of open-end or closed-end wrenches.
Assembly1. Press a 50mm Square Outer Cap (11) onto each end
of the Small Stabilizer (14).
Attach the Small Stabilizer (14) to the Front Leg (12)
with two M10 x 65mm Carriage Bolts (21) and two
M10 Nylon Locknuts (6). Note: There is an indenta-
tion around the holes on one side of the Small
Stabilizer.This side must be facing the floor.
1
21
6
12
11
11
14
2. Press a 50mm x 70mm Outer Cap (5) onto each end
of the Large Stabilizer (15).
Turn the Large Stabilizer (15) so the warning decal is
in the position shown. Attach the Large Stabilizer (15)
to the Bench Frame (3) with two M10 x 65mm
Carriage Bolts (21) and two M10 Nylon Locknuts (6).
Note: There is an indentation around the holes on
one side of the Large Stabilizer.This side must be
facing the floor.
2
21
3
5
6
5
15
Decal