NordicTrack NTBE01490 manual Nylon Locknut the Seat Adjustment Bracket must pivot easily

8.Press a 25mm x 50mm Inner Cap (27) into the open end of the Seat Support Tube (20).

Lubricate an M8 x 80mm Bolt (29). Attach the Seat Adjustment Bracket (22) to the indicated side of the Seat Support Tube (20) with the Bolt and an M8 Nylon Locknut (30). Note: Do not overtighten the

Nylon Locknut; the Seat Adjustment Bracket must pivot easily.

9.Place the Seat Support Tube (20) on the Bench Frame (3) so that the Seat Adjustment Bracket (22) fits over the welded pin (not visible in the drawing) on the side of the Bench Frame.

Lubricate an M10 x 80mm Bolt (25). Attach the Seat Support Tube (20) to the indicated bracket on the Bench Frame (3) with the Bolt and an M10 Nylon Locknut (6). Note: Do not overtighten the Nylon

Locknut; the Seat Support Tube must pivot easily.

10.Attach the wide end of the Seat (8) to the bracket on the Seat Support Tube (20) with two M6 x 16mm Screws (1).

Tilt the Seat Support Bracket (20) upwards and attach the narrow end of the Seat (8) to the Seat Support Bracket with an M6 x 38mm Bolt (28) and an M6 Washer (18).

11.Attach the Curl Pad (7) to the bracket on the Front Leg (12) with two M6 x 16mm Screws (1).

12.Make sure that all parts are properly tightened before you use the weight bench.

8	29
	22	20
Lubricate
	27	30
9	20
		Lubricate
	22
	25
	Pin
	3	6
10
	8
	20
		18
	1	28
11	7
		1
	12

8