For Machines Mfg. Since 8/09 | P R E P A R A T I O N | Model SB1040/SB1041 |
Test Run
After all preparation steps have been completed, the machine and its safety features must be tested to ensure correct operation. If you discover a problem with the operation of the machine or its safety components, do not operate it further until you have resolved the problem.
Note: Refer to Troubleshooting on Page 44 for solutions to common problems that occur with all metal bandsaws. If you need additional help, contact our Tech Support at (360)
To reduce the risk of serious injury when using this machine, read and understand this entire manual before beginning any operations.
Note: For
ssIf the blade is moving in the upward direction out of the table, stop the machine immediately. It is likely wired "out of phase." To correct this problem, refer to Correcting Phase Polarity on Page 20.
7.Adjust the blade speed through the full range of operation. The speed should change as you make the adjustments.
8.Press the STOP button, the green motor light will go out, and the bandsaw will stop.
9.Turn the work lamp and the welding lamp ON and OFF.
10.Turn the grinder ON and OFF.
To test run your machine:
1.Read and follow the safety instructions at the beginning of the manual, take required safety precautions, and make sure the machine is set up and adjusted properly
2.Clear away all tools and objects used during assembly and preparation.
3.Make sure the blade is properly tensioned and the blade guides are positioned correctly (for detailed instructions, refer to Blade Tensioning on Page 27, and Adjusting Blade Guides on Page 30).
4.Connect the machine to the power source.
5.Push the ON button. The green motor light will illuminate and the motor will start.
6.Verify that the machine is operating correctly. When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.
Inspections &
Adjustments
The following list of adjustments were performed at the factory before your machine was shipped:
ss | Blade Guide Adjustment | Page 30 |
ss | Page 39 | |
ss | Table Calibration | Page 41 |
ss | Blade Tracking | Page 41 |
ss | Guide Post Alignment | Page 42 |
Be aware that machine components can shift during the shipping process. Pay careful attention to these adjustments as you test run your machine. If you find that the adjustments are not set according to the procedures in this manual or they do not suit your personal preferences,
