For Machines Mfg. Since 8/09 | S E R V I C E | Model SB1040/SB1041 |
Blade Tracking
A blade that is tracking correctly runs cooler, reduces
To adjust the upper wheel for blade tracking:
1.DISCONNECT BANDSAW FROM POWER!
2.Make sure the blade guides are adjusted away from the blade so they will not interfere with the change of blade position.
3.Ensure that the blade is correctly tensioned.
4.Using a 6mm hex wrench, loosen the four locking cap screws (see Figure 45).
Adjustment Set
Screw
Upper
Wheel
Housing
Locking
Cap Screw
Figure 45. Wheel alignment.
5.Use a 5mm hex wrench to adjust the four set screws (Figure 45) to tilt the upper wheel in or out and bring blade tracking back to normal. Only adjust each screw in small increments.
6.Rotate the upper wheel by hand a couple times in the normal direction of rotation. Verify that the blade tracks next to, but not against, the wheel flange. Repeat Steps
7.Tighten the locking cap screws and recheck the tracking to make sure it did not change. If it did, repeat Steps
8.Adjust the blade guides back to their correct position.
Table Calibration
To ensure the accuracy of angle cuts and compound angle cuts, the scale pointers must point to zero when the table is perpendicular or 90° to the blade.
To calibrate the table to zero:
1.DISCONNECT BANDSAW FROM POWER!
2.Make sure the blade tracking and tension are set correctly.
3.Using a 6mm hex wrench, loosen the trunnion cap screws (see Figure 46).
! | Trunnion Cap |
Screws | |
| Feed Angle |
| Cap Screw |
Feed Angle | Cut Angle |
Scale | Scale |
Figure 46. Location of table scales.
4.Place a machinist's square on the table and against the side of the blade, as shown in
Figure 47.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 9O |
| Blade |
|
| MachinIst's |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Square |
|
|
|
| Table |
|
|
|
|
|
| |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
