8.Identify the Left Pedal (22), which is marked with an “L.” Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the Left Crank Arm (24). Tighten the Right Pedal (not shown) clockwise into the Right Crank Arm. Important: Tighten both
Pedals as firmly as possible. After using the exercise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tightened.
Identify the Left Pedal Strap (25), which is marked with an “L.” Attach the Left Pedal Strap to the Left Pedal (22), and adjust it to the desired position.
Adjust the Right Pedal Strap (not shown) in the same way.
8
25
22
24
9.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor.
Remove the access door from the underside of the Console (4). You may need to use a small standard screwdriver to remove the access door.
Slide the receiver onto the indicated plastic pin on the Console (4); make sure that the receiver is oriented exactly as shown. Locate the two small screws included with the chest pulse sensor. Attach the receiver to the Console with the two screws as shown.
Connect the wire on the receiver to the indicated wire on the Console (4).
Reattach the access door. Make sure that no wires are pinched. Note: The other wires included with the chest pulse sensor may be discarded.
Access |
Door |
4 |
Pin |
Wire |
Receiver |
Screws |
7
