NordicTrack NTC05941 Upper Wire Harness, Do not pinch, Wire Harnesses, 42, 43 during, This step

2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 40mm Button Screws (54) and four M8 Split Washers (55).

3.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (42) to the Lower Wire Harness (43). Carefully pull the upper end of the Upper Wire Harness to remove the slack from the Wire Harnesses.

Make sure that the Upright (2) is turned so the top slopes down in the direction shown. Slide the Upright onto the Frame (1). Be careful to avoid pinch- ing the Wire Harnesses (42, 43). Attach the Upright to the Frame with four M8 x 44mm Button Screws (77), four M8 Split Washers (55), and three 6.6mm Spacers (76). Make sure that the curved sides of the

Spacers are facing the Upright.

4.Hold the Handlebar (3) near the Upright (2). Feed the Upper Wire Harness (42) up through the indicated hole in the Handlebar. Attach the Handlebar to the Upright with two M8 x 25mm Patch Screws (59) and two M8 Split Washers (55). Be careful to avoid pinching the

Upper Wire Harness.

2
1
16
	55
55	54
54
3
Top must
slope down in
this direction.
2	Do not pinch the
	Wire Harnesses
76	(42, 43) during
	this step.
77
55	76
	55
	77
1	42
	43
4	Do not pinch
	the Upper
	Wire Harness
	(42) during
	this step.
	59
55	Hole
3	42
	2

5