Advanced Onscreen Menu Options
·MARK: Selecting Mark ON puts a
TROUBLESHOOTING
If there’s no camera picture on your TV (wireless connection):
1.Make sure your Wireless Video Receiver is connected to power and turned On.
Follow the step on page 27 to bring up the onscreen menu. Then use the Down arrow to select past the last item (PRESET), or the Up arrow to select past the first item (IRIS).
This will display the MARK menu.
Select MARK with the Right Arrow. Then select OFF or ON with the Up and Down arrows. Select with the Right Arrow, and then back out to the main menu with successive presses of the Left arrow.
2.Select the appropriate video input on your TV. Usually you can select the input mode by pressing the VIDEO or INPUT button on the remote control. Or you might have to change the TV to Channel 0 or 2, and then use Channel Down to change video inputs. See your TV’s owner’s manual if you still aren’t sure how to change the video source.
3.Make sure your camera is connected to power and turned on. Press C1 on the remote to turn it on.
4.Check that the mode switch on the bottom of the camera is set to Transmit Enable.
Bottom of camera
5.Follow the setup instructions again (pages 4 through 11), and check that you have done each step correctly.
6.Make sure that the ABCD switches on the bottom of the camera and the bottom of the wireless video receiver are set to the same letter (see pictures on next page).
38 | 39 |
