2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 40mm Button Screws (54) and four M8 Split Washers (55).
3.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (97) to the Lower Wire Harness (43). Gently pull the upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses.
Insert the Upright (2) into the Frame (1). Be careful to avoid pinching the Wire Harnesses (43, 97). Attach the Upright with two M10 x 118mm Button Screws (78), two M10 Split Washers (88), and two Upright Spacers (99). Make sure the concave end of each Upright
Spacer is turned toward the Upright.
4.Identify the Left Handlebar (70), which is marked with an “L” sticker. Hold the Left Handlebar near the Upright
(2). Connect the left Pulse Sensor Wire (6) to the Pulse Wire (3).
Slide the Left Handlebar (70) onto the indicated tube on the Upright (2). Be careful to avoid pinching the left Pulse Sensor Wire (6) or the Pulse Wire (3).
Carefully insert two M8 x 40mm Button Bolts (81) through the Left Handlebar and the tube on the Upright. Be careful not to damage the Wires with the Button Bolts. Tighten the two Button Bolts into two M8 Nylon Locknuts (89). Make sure the Nylon
Locknuts are seated in the hexagonal holes in the Left Handlebar.
Attach the Right Handlebar (72) in the same way.
2 |
|
| |
| 1 |
| |
16 |
|
| |
|
| 55 | |
| 55 | 54 | |
|
| ||
| 54 |
| |
3 |
|
| |
| 2 |
| |
78 | 97 | Make sure the | |
| |||
| 43 | wire harnesses | |
| 99 | do not get | |
| pinched and | ||
88 |
| ||
1 | damaged during | ||
99 | this step. | ||
| |||
4 |
|
| |
Make sure the wires |
| ||
do not get damaged | 72 | ||
during this step. |
| ||
| Tube |
| |
81 | 3 |
| |
| 6 | 2 | |
|
| ||
70 |
|
| |
| 89 |
| |
6
