INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 11), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor.
1.Remove the four indicated screws from the back of the Console (3). Lift the top of the Console. Be careful not to disconnect any wires.
1 |
Screws |
3 |
2.Peel the paper off the adhesive pad on the back of the receiver (A). Orient the receiver as shown, and press it onto the Console (3) in the indicated location.
Connect the wire on the receiver (A) to the short jumper wire (B) as shown. Plug the other end of the short jumper wire into the indicated jack (C).
See step 1 above. Reattach the top of the Console (3) with the four screws. Make sure that no wires are pinched.
Note: Any other wires that are included with the chest pulse sensor may be discarded.
2 |
C |
B |
A |
3 |
8
