10.Attach the Right Pedal Arm (58) to the Right Pedal Bracket (64) with two M10 x 45mm Patch Screws (99).
Repeat this step for the Left Pedal Arm (44).
11.Identify the Right Pulse Bar (9), which is marked with a "Right" sticker.
See the inset drawing. Locate the wire tie in the Upright (4). Tie the lower end of the wire tie to the Pulse Wire (63) in the Right Pulse Bar
(9). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie.
Slide the Right Pulse Bar (9) onto the right side of the Upright (4). Make sure that the hexago- nal holes are in the indicated location.
Tip: Avoid pinching the wires. Attach the Right Pulse Bar (9) with two M8 x 38mm Bolts
(96)and two M8 Locknuts (102). Make sure that the Locknuts are in the hexagonal holes.
Repeat this step for the Left Pulse Bar (8).
10
44
58
11
Avoid pinching the wires
Tie
110
Hexagonal
Holes96
Wire Tie
Ill"63
10
