ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
In addition | to the | included tool(s), assembly requires a Phillips screwdriver _====_, | two adjustable |
wrenches | _, | and a rubber mallet _. |
|
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe- ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
H 1
M8 Split | 16mm | Wave | 19mm | Wave | M10 Washer | M8 x 25mm |
Washer | Washer | Washer | Washer |
M8 Locknut | M10 Locknut | M4 x 16mm | M8 x 19mm Patch | M8 x 38mm |
| Screw | Screw | Bolt |
M8 x 80mm Patch | MIO x 45mm Patch |
Screw | Screw |
M10 x 60mm
Bolt
5