![](/images/new-backgrounds/1145736/14573619x1.webp)
12. Apply a generous amount of grease to the axle | 12 |
|
|
on the Left Upper Body Leg (24) and to the axle |
|
| |
| 24 |
| |
on the left Crank Arm (55). Then, apply grease |
|
| |
to two Large Wave Washers (102). |
|
| 32 |
|
| Grease | |
Slide an Upper Body Leg Spacer (9) and a |
|
|
|
Large Wave Washer (102) onto the Left Upper |
| 102 | 9 |
Body Leg (24). Make sure that the flat side of |
| 31 |
|
the Upper Body Leg Spacer is facing out- |
|
| |
|
|
| |
ward. Then, slide the other Large Wave Washer | 66 |
| |
onto the left Crank Arm (55). |
|
|
|
Slide the left Pedal Arm (32) onto the Left Upper | 86 | 95 |
|
| 32 | ||
Body Leg (24) while sliding the left Link Arm |
| ||
|
|
| |
(30) onto the axle on the left Crank Arm (55). |
|
|
|
Attach the Pedal Arm (32) to the Left Upper |
|
| 30 |
Body Leg (24) with an M8 x 23mm Button |
|
| |
|
|
| |
Screw (86), an M8 Washer (95), an Axle Cover |
|
|
|
(66), and an M8 x 23mm x 1mm Washer (31). |
|
|
|
Then, attach the Link Arm (30) to the Crank Arm |
|
|
|
(55) with an M8 x 23mm Button Screw (86), an |
|
|
|
M8 Washer (95), a Large Axle Cover (52), and |
|
|
|
an M8 x 23mm x 1mm Washer (31). |
|
|
|
Repeat this step for the right Pedal |
| 30 | 102 |
|
| ||
|
|
| |
Arm (32) and the right Link Arm (30). |
|
| 31 |
|
| 95 | 55 |
See step 4. Tighten the M8 x 19mm Button |
|
| |
|
| Grease | |
Screws (85). |
|
| |
|
| 52 | |
|
| 86 | |
|
|
|
13.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
10