3.Slide an M8 Split Washer (58) and an M8 Washer (33) onto an M8 x 19mm Screw (30). Tighten the Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle.
Align the indicated tubes on the Incline Frame (5) with the tubes on the Frame (1). Make sure that the
Incline Frame is turned so the
Slide an M8 Split Washer (58) and an M8 Washer (33) onto the other M8 x 19mm Screw (30). Tighten the Screw into the open end of the Incline Axle (29).
4.Connect the wire harness on the Console (87) to the Extension Wire Harness (51).
Attach the Console (87) to the Upright (2) with the four Console Screws (35) and the four Console Washers
(93)packaged with the Console. Be careful to avoid pinching the wire harnesses.
Snap the bookrack onto the Console (87) in the location shown.
5.Remove the four M10 Nylon Locknuts (26) from the welded bolts on the front of the Frame (1).
While a second person holds the Upright (2) near the Frame (1), connect the Extension Wire Harness (51) to the Wire Harness (85).
Align the four holes in the bracket at the bottom of the Upright (2) with the welded bolts on the Frame (1). Lower the Upright, feeding all slack Extension Wire
Harness (51) and Wire Harness (85) into the Upright, until the welded bolts are inserted into the bracket. Do not allow the Wire Harnesses to be pinched.
Lift the front of the Incline Frame (5). Tighten the four M10 Nylon Locknuts (26) onto the welded bolts on the Frame (1).
6
3 |
|
|
|
|
| ||
|
| 5 |
|
|
| 33 | 58 |
|
|
| 30 |
Grease | 29 | Tubes | |
|
| ||
33 |
|
|
|
58 |
|
|
|
|
| Tubes | |
30 |
| 1 |
|
4 |
|
|
|
84 |
| Bookrack | |
Wire |
| 87 |
|
Harness |
|
| |
51 |
|
|
|
93 |
| 2 |
|
|
|
| |
35 | 35 |
|
|
5 |
|
|
|
Make sure the |
|
| |
Wire Harnesses | 2 |
| |
(51, 85) do not |
| ||
|
| ||
get pinched and |
|
| |
damaged during |
|
| |
this step. |
| 26 |
|
|
|
| |
|
| 26 |
|
|
| 51 |
|
|
| 1 |
|
|
| 85 |
|
5 |
|
|
|
|
| Welded Bolts |
|
