MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the exercise cycle regularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries should be replaced. See assembly step 5 on page 6 for replacement instructions. If the console does not display your heart rate when you use the handgrip pulse sensor, see step 5 on page 13.
HOW TO LEVEL THE EXERCISE CYCLE
HOW TO ADJUST THE REED SWITCH |
| |
If the console does | 4 |
|
not display correct |
| |
|
| |
feedback, the reed |
|
|
switch should be |
| 8 |
adjusted. First, use a |
|
|
small flat screwdriver |
|
|
to carefully pry off the |
| 14 |
left Side Shield |
| |
|
| |
Cover (14). Next, |
|
|
rotate the left Pedal
Guard (8) and pull it away from the Left Side Shield (4).
Next, locate |
| |
the Reed |
| |
Switch (49). |
| |
Turn the Left | 15 | |
Crank Arm (15) | ||
| ||
until the |
|
If the exercise cycle does not sit flat on your floor, turn one or both of the level- ing feet until the exercise cycle is level.
Leveling |
Feet |
Magnet (23) is |
|
|
aligned with | 49 |
|
the Reed | 23 | |
Switch. | 54 |
|
Loosen, but do |
| |
|
| |
not remove, |
|
|
the indicated |
|
|
M4 x 16mm |
|
|
Screw (54). |
|
|
Slide the Reed Switch slightly closer to or away from | ||
the Magnet. Then, retighten the Screw. Turn the Left | ||
Crank Arm for a moment. Repeat until the console |
displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left Pedal Guard (8) and the left Side Shield Cover (14).
17