NordicTrack NTL10951 user manual Assembly

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver and

wire cutters . For help identifying the assembly hardware, see the hardware drawings below.

Star Washer (67)–8	3/4” Tek Screw (44)–4	1” Tek Screw (82)–2
		Short Console
		Bolt (112)–2
Extension Screw	3/4” Screw (7)–2	Pulse Bar Bolt (66)–4
(87)–4
	Console Bolt (72)–2

1.With the help of a second person, carefully raise the Upright Base (85) and the Frame (55) to the position shown.

While the other person holds the Frame (55) and the Upright Base (85), insert the Base Extension (90) into the two brackets on the lower end of the Upright Base. Make sure that the Base Extension is turned so the Base Pads (81) are beneath it. Note: It may be helpful to tip the Upright Base forward as you insert the Base Extension.

1
		55
		Brackets
81	90	85
		81

6