8.Set the console assembly on the Upright Base (85). Make sure that no wires are pinched. Finger tighten a Console Bolt (72) with a Star Washer (67) into the lower hole in each side of the Upright Base (only one side is shown).
Next, finger tighten a Short Console Bolt (112) with a Star Washer (67) into the upper hole in each side of the Upright Base (85) (only one side is shown). Be careful not to drop the Short Console Bolts into the Upright Base. Firmly tighten the Console Bolts (72) and the Short Console Bolts.
Insert an Upright Endcap (71) into one side of the Upright Base (85). (Note: Insert the end of the Upright Endcap in- dicated by the arrow first; use a rubber mallet if neces- sary.) Insert an Upright Endcap into the other side of the Upright Base in the same way.
8
71 |
|
67 |
|
112 |
|
85 |
|
67 | Console |
| |
72 | Assembly |
|
9.Remove the knob from the pin. Make sure that the collar and the spring are on the pin.
Press the Latch Insert (77) into the left side of the Upright Base (85) as shown. Use a rubber mallet if necessary. Insert the pin into the Latch Insert. Tighten the knob back onto the pin.
9 |
|
Knob |
|
| 77 |
| Spring |
| Collar |
85 | Pin |
|
10.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the
floor or carpet from damage, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated 3/4” Screw (7) and the Access Door (95) from the left side of the Console Back (96).
2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (96). Hold the re- ceiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (95) with the two in- cluded small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (95) with the 3/4” Screw (7). The other wires included with the receiver may be discarded.
|
| Small |
|
| Screws |
|
| 96 |
95 |
| Wire |
|
| A |
| 7 | Small |
| Cylinder | |
|
|
9
