NordicTrack NTL10951 user manual

5.Slide the two Upright Covers (75) onto the ends of the Pulse Bar (69). Align the holes in the lower ends of the Pulse Bar with the holes in the Upright Base (85).

Cut the tie securing the Pulse Wire (74) to the Upright Base (85). Do not cut the indicated tie. Connect the Pulse Wire to the Pulse Bar Wire (79). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the wires down into the right side of the Upright Base.

Hold the Pulse Bar (69) against the Upright Base (85). Do not drop the Pulse Bar into the Upright Base. Attach the Pulse Bar to the Upright Base with the four Pulse Bar Bolts (66) and four Star Washers (67). Be careful not to pinch the wires. Start all four Pulse Bar Bolts before tightening them.

Slide the Upright Covers (75) over the Pulse Bar Bolts (66).

6.Press the two Upright Covers (75) onto the Upright Base (85). Attach each Upright Cover with a 3/4” Screw (7).

7.Cut the tie securing the Wires to the Upright Base (85). Have a second person hold the console assembly near the Upright Base (85). Connect the Upright Wire Harness (73) and the Pulse Wire (74) to the wires extending from the console assembly. The connectors should slide together easily and snap into place. If they do not, turn one con- nector and try again. Insert the connectors into the Console Assembly. If necessary, remove the right acces- sory tray (not shown) from the console assembly.

Connect the Upright Ground Wire (113) to the ground wire extending from the console assembly. Make sure that the wires are fully inserted into each other. Insert the ground wires into the Console Assembly. Reinsert the right acces- sory tray (not shown) into the console assembly if neces- sary.

5
75		69
67		Do Not
		Cut
66	85
		75
79		79
		85
74
		67
		74
		66
6
75		75
7		7
85		85
7
Console
Assembly

Ground	74
Wire

113

74

73 73

85

8