If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screw (7) and the Access Door (95) from the left side of the Console Base (98).
2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base
(98). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (95) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (95) with the Screw
(7). Discard the other wires included with the re- ceiver.
98 | Wire |
| |
| Small |
| Screws |
95 |
|
| A |
| Small |
7 | Cylinder |
9
