2.Attach the four Base Pads (81) to the bottom of the Upright (20) with the four 1” Tek Screws (82) in the locations shown.
3.With the help of a second person, carefully raise the Upright (20) to the vertical position. Remove the band securing the Upright Wire Harness (73) to the right Upright. Have a second person hold the console assembly near the right Upright.
Connect the Upright Wire Harness (73) to the console wire extending from the console assem- bly. Make sure to connect the connectors properly (see the inset drawing). The connec- tors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors into the right Upright (20).
4.Carefully set the console assembly onto the top of the Upright (20) as shown. Make sure that no wires are pinched. Attach the console assem- bly to the Upright with four Star Washers (67) and four Handrail Bolts (72). Start all four
Handrail Bolts before tightening them.
2 |
|
|
| 82 | 81 |
|
| |
|
| 81 |
|
| 82 |
| 82 |
|
|
| 81 |
|
| 20 |
|
| 81 |
|
| 82 |
3 |
|
|
|
| Console |
|
| Assembly |
|
| Console Wire |
|
| 73 |
|
| 20 |
|
| 73 |
4 |
| Console Assembly |
|
|
72 
6767
20
7
