![](/images/new-backgrounds/1134196/13419627x1.webp)
If the speed or incline setting is too high or too low during the program, you can manually override the setting by pressing the Speed or Incline but- tons on the console. Every few times one of the Speed buttons is pressed, an additional indicator will light or darken in the Current Segment column. (If any of the columns to the right of the Current Segment column have the same number of lit indi- cators as the Current Segment column, an addi- tional indicator may light or darken in those columns as well.) Note: If you manually adjust the speed setting so that all of the indicators in the Current Segment column are lit, the speed settings in the program display will not move downward as described above. Note: If you manually override the speed or incline setting, when the next seg- ment begins, the treadmill will automatically adjust to the speed and incline settings for the next segment.
To stop the program temporarily, press the Stop button. The time will begin to flash in the main dis- play. To restart the program, press the Start button or the Speed + button. The walking belt will begin to move at 1 mph. When the next segment begins, the treadmill will automatically adjust to the speed and incline settings for the next segment. To end the program, press the Stop button, remove the key, and then reinsert the key.
4 Follow your progress with the displays.
See step 5 on page 11.
5 Measure your heart rate if desired.
See step 6 on page 12.
6 Turn on the fans if desired.
See step 7 on page 12.
7 Whenkey. you are finished exercising, remove the
Step onto the foot rails and make sure that the in- cline of the treadmill is at the lowest level. Next, remove the key from the console and put it in a se- cure place. Note: If the displays and indicators on the console remain lit after the key is re- moved, the console is in the “demo” mode. See page 24 and turn off the demo mode.
When you are finished using the treadmill, move the on/off circuit breaker switch near the power cord to the off position and unplug the power cord.
14