If you purchase the optional chest pulse sensor, follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. While holding the Upper Handrail (123), remove the two 3” Bolts (119) and Handrail Washers (120).
4.Connect the included short jumper wire (B) to the wire on the receiver (A). Connect the other end of the short jumper wire to the PLS2 jack on the back of the Console (82) (if there is a wire already plugged into the PLS2 jack, unplug it). Note: The other wires included with the receiver may be dis- carded. Use the included wire tie to secure wires, if needed.
1 |
123 |
69 |
120 |
119 |
2.Remove the indicated screws from the Console Back (88). Important: The screws may be different lengths; remember which screws were removed from which holes. Remove the Console (81).
2 | 81 |
| 88 |
| Screws |
4 |
PLS2 |
Jack |
82 |
B |
A |
5.See step 2. Reattach the Console (81) with the screws; make sure that no wires are pinched.
Important: If the screws are not put back into the same holes from which they were removed, the Console will be damaged.
See step 1. Reattach the Upper Handrail (123).
3.Peel the paper off the pad on the bottom of the re- ceiver (A). Turn the receiver so the small cylin- der is on the side shown, and press the receiver onto the bottom of the Console Base (81) in the in- dicated location.
3 |
A |
Cylinder |
81 |
25 |
