5.Cut the tie securing the wires to the right Upright (20). Have a second person hold the console assembly near the Uprights. Connect the Upright Wire Harness (73) and the Pulse Wire (74) to the wires extending from the console as- sembly. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the connectors into the console as- sembly. If necessary, remove the right accessory tray (not shown) from the console assembly.

Connect the Upright Ground Wire (113) to the ground wire extending from the console assembly. Make sure that the wires are fully inserted into each other. Insert the ground wires into the console assembly. Reinsert the right acces- sory tray (not shown) into the console assembly if neces- sary.

6.Set the console assembly on the Upright (20). Make sure that no wires are pinched. Finger tighten a Console Bolt (72) with a Star Washer (67) into the lower hole in the Upright. Repeat on the other side.

Next, finger tighten a Short Console Bolt (112) with a Star Washer (67) into the upper hole in the Upright (20).

Be careful not to drop the Short Console Bolts into the Uprights. Repeat on the other side. Firmly tighten the two Console Bolts (72) and the two Short Console Bolts. Repeat on the other side.

Insert the Upright Endcaps (71) into the top of each Upright (20) (only one side is shown). Note: Insert the end of the Upright Endcap indicated by the arrow first; use a rubber mallet if necessary.

7.Slide the two Upright Covers (75) onto the lower ends of the Handrails (68, 70). Next, align the slots in the lower ends of the Handrails with the holes in the Upright (20) as shown. Do not drop the Handrails into the Upright or cut the indicated black tie.

Next, loosely thread four Handrail Bolts (66) with Star Washers (67) into the Handrails (68, 70) and the Upright (20). Make sure that the Handrails are centered in the

Upright, and firmly tighten the four Handrail Bolts.

5

 

Console

 

Assembly

 

Ground

74

Wire

 

113

 

 

73

 

73

20

74

6

 

71

 

20

 

67

 

112

 

67

Console

 

Assembly

72

 

7

 

68

 

75

 

 

70

66

67

Do

20

Not

 

 

 

75

Cut

 

 

20

 

 

67

 

66

 

8

Page 8
Image 8
NordicTrack NTL2295.0 user manual Upright, and firmly tighten the four Handrail Bolts, Not, Cut