ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials, unless otherwise instructed. Do not dispose of the packing materials until assembly is completed. Assembly requires
the included allen wrench and your own 
, wire cutters 
,
and adjustable wrench
.
Note: The underside of the treadmill walking belt is coated with
1.With the help of a second person, carefully raise both Uprights (83) to a vertical position. Remove any packag- ing from the crossbar.
Remove the elastic holding the Upright Wire Harness
(131)in the right Upright (83). Have a second person hold the Handrails (73) near the Uprights. Connect the Upright Wire Harness to the wires extending from the Console Base (120). The connectors should slide to- gether easily and snap into place. If they do not, turn one connector and try again. Insert the connectors and the Upright Wire Harness into the hole in the right Upright. Then, set the Handrails on the Uprights, being careful not to pinch the wires.
2.Insert two 4 1/2” Bolts (96) with Handrail Spacers (95) into the right Upright (83). Next, lift the right Handrail (73) slightly and align the Handrail Bolts with the holes in the Handrail. Thread the Handrail Bolts into the Handrail. Do not tighten the Handrail Bolts yet. Be careful not to pinch the wires.
Attach the left Handrail (not shown) in the same way. Make sure that the Handrail Spacers (95) are flush against the Uprights (83), with the thick sides facing the center of the treadmill, as shown in the inset drawing. Then, tighten all four Handrail Bolts (96).
3.With the help of a second person, carefully tip both Uprights (83) to the floor.
Insert the three Cage Nuts (28) into the three indicated holes in the treadmill.
To insert each Cage Nut (28), first hook one side of the Cage Nut into a hole and then use a
1 | 120 |
| |
| 131 |
| 83 |
73 | Crossbar |
| |
2 |
|
| 83 |
| 95 |
73 |
|
| Thick |
| Side |
| 95 |
| 96 |
3 |
|
| 83 |
| 28 |
| 28 |
6
