4.Be careful to avoid pinching your hands or the Wire Harness (not shown) during this step.
While a second person holds the Uprights (95, 97), re- move the two Upright Bolts (96) used in step 1. Next, slide the Uprights fully onto the brackets on the Frame (not shown). Attach each Upright with four Upright Bolts (96) as shown. Firmly tighten all eight Upright Bolts.
Firmly tighten the eight Handrail Bolts (99).
5.Plug the indicated end of the Power Cord (48) fully into the treadmill as shown.
6.After the treadmill is moved to the location where it will be used (see HOW TO MOVE THE TREADMILL below), make sure that both Rear Feet (5) and both Wheels (not shown) rest firmly on your floor. If the treadmill rocks slightly on your floor, loosen the Rear Foot Locknut (111) above the right Rear Foot. Turn the right Rear Foot clockwise or counterclockwise until the rocking motion is eliminated. Then, retighten the Rear Foot Locknut.
4 |
99 |
99 |
99 |
97 |
95 |
96 |
96 |
5 |
48 |
6 |
|
| 111 |
| 5 |
111 | 5 |
7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrenches for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill.
HOW TO MOVE THE TREADMILL
Note: It may be helpful to leave the treadmill at an in- cline while moving the treadmill. Before moving the treadmill, make sure that the power cord is un- plugged from the wall outlet.
Due to the size and weight of the treadmill, moving it requires two persons. While one person lifts the indi- cated end, firmly hold the handrails and tip the treadmill forward until it rolls on the front wheels. Carefully move the treadmill to the desired location and then lower it.
CAUTION: To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over uneven surfaces.
Lift | Handrails |
Here |
|
| Wheels |
7
