16.Wrap the Press Arm Cable (30) under a 3 1/2" Pulley (24). Attach the Pulley, a Cable Trap (28), and two Half Finger Guards (26) to the Weight Tube (11) with an M10 x 48mm Bolt (62) and an M10 Nylon Locknut (73) at the indicated hole.
Make sure the Finger Guards are oriented as shown and are on the outside of the Weight Tube. Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.
17.Wrap the Press Arm Cable (30) over a 3 1/2" Pulley (24). Attach the Pulley and a Cable Trap (28) to the Top Frame (4) with an M10 x 45mm Bolt (65) and an M10 Nylon Locknut (73). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.
18.Route the Press Arm Cable (30) through the Top Cover (15).
Wrap the Press Arm Cable (30) over a 3 1/2" Pulley (24). Attach the Pulley and a Cable Trap (28) to the Top Frame (4) with an M10 x 45mm Bolt (65) and an M10 Nylon Locknut (73). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.
19.Attach the Press Arm (8) with the wire to the Upright (3) with four M10 x 25mm Screws (58).
Remove the M4 x 5mm Screw (69) and the Swivel Arm (16).
Using the wire that is inserted into the Press Arm (8), route the Press Arm Cable (30) through the Press Arm as shown. Route the Cable through the Swivel Arm (16).
Reattach the Swivel Arm (16) to the Press Arm
(8) with the M4 x 5mm Screw (69).
16 |
|
|
|
| 11 | 73 | 30 |
|
| ||
62 |
|
| 26 |
|
|
| 28 |
|
| 26 | 24 |
17 | 28 |
|
|
|
|
| |
65 |
| 30 |
|
|
| 73 |
|
| 24 |
| 4 |
18 |
|
|
|
65 |
|
|
|
28 | 24 | 15 | 4 |
|
| 30 |
|
|
| 73 |
|
19 |
|
|
|
16 |
|
|
|
| 30 |
|
|
69 | 58 |
|
|
8 |
|
|
|
58 |
|
|
|
| 3 |
|
|
11
