NordicTrack NTTL15083 manual Assembly

Assembly

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Assembly

requires the included allen wrench and your own phillips screwdriver and adjustable

wrench .

1.With the help of a second person, carefully raise the Uprights (70) until the Wheels (30) are resting flat on the floor.

2.Remove the four Screws (43) from the posts on the left and right Uprights (70). Slide the upper end of a Handrail (101) onto the right Upright (70) as shown. Note: It will be necessary to pivot the Handrail to the side and back repeatedly (see arrow A) while pushing on the Handrail (see arrow B) to slide it fully onto the Upright.

Next, pivot the lower end of the Handrail down, push it toward the right Upright, and then align it with the indi- cated hole.

Tighten two Screws (43) into the upper end of the Handrail (101) and the right Upright (70).

Attach the other Handrail (101) to the left Upright (70) as described above.

3.With the help of a second person, carefully tip the Uprights (70) down as shown.

Tighten a Handrail Bolt (95) with a Handrail Washer (102) into the right Upright (70) and the lower end of the right Handrail (101) as shown. Note: It may be necessary to press down on the Handrail to align the holes in the upright and Handrail.

Next, tighten a Handrail Bolt (95) with a Handrail Washer

(102)into the left Upright (70) and the lower end of the left Handrail (101) (not shown).

With the help of a second person, carefully tip the Uprights (70) back to the upright position.

1
	70
		30
2
43	B
		43
	101	70
	70
101
		A
		Hole
3
		95
		102
101	102
	95
		70

6