NordicTrack NTTL15510 manual HOW to USE the PULSE-DRIVEN Program, Select the pulse-driven program

When the cool-down segment is completed, the walking belt will slow to a stop. After the fitness test program is com-

pleted, your fitness level will be shown in the

Time display. There are ten fitness levels— fitness level 10 (FL:10) is the highest. Remem-

ber, the fitness program is intended only to indicate your relative fitness level.

Note: The Speed and Incline buttons will not function while the fitness test program is selected. If your pulse is not detected during the program, the letters “PLS” will flash in the Heart Rate/Calories display. If your pulse is not detected during the last thirty seconds of any 4-minute segment (after 4 minutes, after 8 minutes, etc.), the fitness test pro- gram will end and the Time display will show a fit- ness level of 0 (FL: 0).

The fitness test program cannot be stopped tem- porarily and then restarted. However, the program can be stopped at any time with the Stop button. The Time display will then show an estimated fit- ness level.

6 When the program has ended, remove the key.

See step 6 on page 13.

HOW TO USE THE PULSE-DRIVEN PROGRAM

The pulse-driven program automatically adjusts the speed and incline of the treadmill to keep your heart rate near a target level during your workout. Note: You must wear the optional chest pulse sensor to use the pulse-driven program (see page 24).

CAUTION: If you have heart prob- lems, or if you are over 60 years of age and have been inactive, do not use the pulse-driven program. If you are taking medication regularly, consult your physician to find whether the medication will affect your exercise heart rate.

Follow the steps below to use the pulse-driven program.

1 Put on the chest pulse sensor.

Refer to the instructions included with the chest pulse sensor to put on the chest pulse sensor.

2 Insert the key fully into the console.

See GETTING STARTED on page 10.

3 Select the pulse-driven program.

When the key is inserted,	Indicator
the manual mode will be
selected. To select the
pulse-driven program,
press the Select Program
button repeatedly until the
Pulse Driven indicator

lights. When the pulse-driven program is selected, the program display will show a simplified profile of the program.

4 Enter your age.

When the pulse-driven program is selected, an

age setting will flash in the Incline display and the letters “AGE” will ap- pear in the Time display.

You must enter your age to use the pulse-driven program. If you have already entered your age, go to step 5. If you have not entered your age, press the Enter Age buttons to enter your age. A few seconds after the buttons are pressed, the age setting will disappear from the display. Your age will then be saved in memory.

17