TROUBLESHOOTING

Most ski exerciser problems can be solved by following the steps below. Find the problem that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department.

PROBLEM: The console does not function properly.

SOLUTION: a. Make sure that both ends of the console wire are fully plugged in (see assembly step 6 on page 5).

b.If the console does not function properly, or if the display becomes faint, the batteries should be replaced. See assembly step 5 on page 5 for installation instructions.

PROBLEM: The arm cords are tangled.

WARNING: The pulley will get hot during use. Avoid touching the pulley imme- diately after use.

SOLUTION: a. Detach the handgrips by untying the

 

 

 

 

knots inside of the handgrips and

 

 

 

 

removing the M6 washers (see HOW

 

28

 

28

TO ADJUST THE LENGTH OF THE

28

28

 

 

ARM CORD on page 6). Take the

 

 

 

 

ends of the Arm Cord (23) out of the

 

35

 

 

Small Pulleys (28) and unwind the

 

 

A

 

 

 

Arm Cord from the Pulley (35). Notice

 

23

 

 

 

B

how the Arm Cord goes into the

 

 

 

 

Pulley. Drape both ends of the Arm

 

 

 

 

Cord over the hip pad. Make sure that the ends of the Arm Cord are even.

b.Locate cord “A.” Wrap it counterclockwise around the Pulley (35) until there is no more cord to wind. Do not be concerned if it looks tangled; it will smooth out later.

c.Pass the end of cord “A” from left to right through the right Small Pulley (28). Pull cord “A” to wrap cord “B” around the Pulley (35).

d.Feed the end of cord “B” from right to left through the left Small Pulley (28). Pull cord “B” until the end of cord “B” is even with the end of cord “A.” With a cord in each hand, work the Arm Cord (23) back and forth until it is wrapped evenly around the Pulley (35).

e.To reattach each handgrip, thread the Arm Cord (23) into the small hole in the handgrip, slide an M6 washer onto the Arm Cord, and tie a figure-eight knot as shown at the right near the end of the Arm Cord. Note: To adjust the length of the Arm Cord, see

HOW TO ADJUST THE LENGTH OF THE ARM CORD on page 6.

23

11

Page 11
Image 11
NordicTrack NTXC80182 user manual Troubleshooting, Problem The arm cords are tangled