4.Raise the Upper Body Arm (27) to position as shown.
Make sure that the Snap Buttons (40) are fully extended and locked into position on both sides of the Hip Pad Slide (42).
5.The Console (66) requires two “AA” batteries. Alkaline batteries are recommended. See the inset drawing. Locate the Battery Door (89) on the back of the Console. Press the indicated tab on the Battery Door and remove the Battery Door. Press two batteries into the battery compartment, with the negative ends of the batteries touching the springs. Then, reattach the Battery Door.
Attach the Console (66) to the Upper Body Arm (27) by firmly pressing it into place in the desired location.
6.Plug the Console Wire (47) and the Pulse Monitor (49) into the indicated jacks on the Console (66).
See the inset drawing. Plug the other end of the Console Wire (47) into the jack on the Upright (16).
7.Make sure that all parts are tightened before you use the ski exerciser. To protect the floor from damage, place a mat beneath the ski exerciser.
4 |
|
27 |
|
40 | 42 |
5 |
|
66 |
|
27 |
|
66 |
|
89 |
|
Tab |
|
Batteries |
|
6 |
|
66 |
|
Speed |
|
Pulse |
|
49 |
|
47 | 16 |
| |
47 |
|
5
