Nortec NHDI, NHSC - page 19

power limit screen. To change the power limit, simply
press the down aroow key to desired capacity and
press enter to save that new value. Press menu key
to exit parameter screen.
Inlet Valve Correction
Set inlet valve correction (cycle ratio) in % of
standard setting value to balance out water pressure
variations.
Soft Start
Soft Start activated (on), consult factory.
Deactivated (off) factory set.
Demineral Mode
Demineral mode activated (on), consult factory.
Deactivated (off) factory set.
Serial Interface
Serial Interface activated (on), consult factory.
Deactivated (off) factory set.
Full Drain Cycle
Full Drain Cycle activated (on), consult factory.
Deactivated (off) factory set.
Flush Cycle
Flush Cycle activated (on), consult factory.
Deactivated (off) factory set.
Control Signal
Range of the active analog signal in V or mA,
respectively.
Note: The range of the analog signal may be
adjusted using the rotary switch “S3” on the control
board.
Software Version
Current software version for the steam humidifier.
-16-
Figure #19
NHSC / NHDI Control Interval
Flush Cycle
Off
analog signal
0 - 5v (poti)
software version
VX.XX
inlet valve cor.
130
Soft Start
Off
Demineral Mode
Off
Serial Interface
Off