Network Connection
Locate connectors for Ethernet, antennas, and power on the back of the AP. Ethernet configurations vary according to the environment.
Note: The e-mobility site survey utility can be used to determine the number of access points to install and their locations.
10BASE-T UTP
Use a 10BASE-T connection for multiple access points or an access point attached to a wired UTP Ethernet hub or switch. Normal 10BASE-T limitations apply.
To establish a 10BASE-T connection:
1Plug the data cable RJ-45 connector into the access point RJ-45 connector.
2Plug the other end of the data cable into the LAN access port, possibly a hub or wall connection.
3Add additional access points as needed.
Note: When connecting the e-mobility access point to an Ethernet switch, ensure the switch port parameters are set to 10 Mbps Half Duplex. Severe performance degradation may result from mis-matched speed or duplex modes.
