250 Appendix G Command Interpreter

N0115791

IP commands

Table 59 lists and describes the IP commands. Each of these commands must be

preceded by ip. For example, type ip address to display the host IP address.

disp <name> Displays the Ethernet driver counters.
status <ch_name> Shows the LAN status.
version Displays the Ethernet device type.
edit
load <1:LAN> Loads Ethernet (1:LAN) data from the System
Parameters Table.
mtu <value> Sets the Ethernet data Maximum Transmission
Unit.
accessblock <0:disable 1:enable> Blocks Internet access.
speed <auto|10/half|10/
full|100/half|100/
full>
Sets the Ethernet data speed and duplex.
save Saves Ethernet data to the System Parameters
Table.
dynamic
Port
dump Displays the relationship between physical port
and channel.
set <port> <type> Sets physical port to a specific channel.
spt Displays channel setting stored in SPT.
Table 59 IP commands
Command Description
address [addr] Displays the host IP address.
alias <iface> Sets an alias for the specified interface.
aliasdis <0|1> Disables or enables the alias for the specified
interface.
arp

Table 58 Ether Commands

Command Description