
262 Appendix G Command Interpreter
N0115791
btNatType <0:single |
1:range |
2:all>
Sets the type of NAT address mapping.
btNatAddrStart <IP address> Sets the branch tunnel NAT starting IP
address.
btNatArEnd <IP address> Sets the branch tunnel NAT ending IP
address or subnet mask.
swSkipOverlapIP <on|off> Turn this option on to have the device
allow rules with overlapping source and
destination IP addresses.
adjTcpMss <off|auto|user
defined value>
Sets the adjust TCP Maximum Segment
Size.
contivityDial Initiates the Contivity Client VPN
connection.
contivityDrop Ends the Contivity Client VPN
connection.
contivityState Displays information about the Contivity
Client VPN connection.
contivitySplit
contivityTimecnt <0~65535> Sets the Contivity Client keep-alive
interval (in seconds).
exemptHost Uses the exemptHost commands to
configure specific IP addresses that are
not to be part of a VPN tunnel.
display Displays the exempt host settings.
load <index> Loads an exempt host.
active <Yes|No> Enables or disables an exempt host.
sourceStart Sets the exempt host’s source start IP
address.
sourceEnd Sets the exempt host’s source end IP
address.
destStart <IP address> Sets the exempt host’s destination start
IP address.
destEnd <IP address> Sets the exempt host’s destination end IP
address.
save Saves an exempt host.
btNatList Displays the branch tunnel NAT entries.
Table 60 IPSec commands
Command Description