Appendix G Command Interpreter 261
BCM50a Integrated Router Configuration — Advanced
ikeDelete <rule index> Deletes the specified IPSec rule.
policyEdit <rule index> Edits the specified IP policy.
policySave Saves the IP policy.
ipsecList Displays a summary of the IPSec (phase
2) rules.
policyList Displays the IP policies.
policyDelete <rule index> Deletes the specified IP policy.
policyConfig Uses these commands to configure an IP
policy for an IPSec office tunnel rule.
saIndex <rule index> Binds the IP policy to an IPSec rule.
active <Yes|No> Turns the IP policy on or off.
lcAddrStart <IP> Sets the local starting IP address.
protocol <1:ICMP | 6:TCP
| 17:UDP>
Sets the IP policy’s protocol.
controlPing <Yes|No> Turns control ping on or off.
controlPingAddr <IP> Sets the control ping IP address.
lcAddrType <0:single |
1:range |
2:subnet>
Sets the local address type.
lcAddrEndMask <IP> Sets the local ending IP address or
subnet mask.
lcPortStart <port> Sets the local starting port number.
lcPortEnd <port> Sets the local ending port number.
rmAddrType <0:single |
1:range |
2:subnet>
Sets the remote address type.
rmAddrStart <IP> Sets the remote starting IP address.
rmAddrEndMask <IP> Sets the remote ending IP address or
subnet mask.
rmPortStart <port> Sets the remote starting port number.
rmPortEnd <port> Sets the remote ending port number.
btNatActive <Yes | No> Turns branch tunnel NAT address
mapping on or off.
Table 60 IPSec commands
Command Description