GENERATOR FEATURES
Reference 1 - Muffler. Allow 3’ clearance around the hot exhaust gas.
Reference 2 - Gas Cap.
Reference 3 - Engine Stop Switch. The rocker
engine stop switch is located on the engine. I means ON. O means OFF.
Reference 4 - Recoil. Grasp firmly when starting engine.
Reference 5 - Air Cleaner. Refer to your Tecumseh engine manual for air cleaner care.
Reference 6 - Vibration Isolation Mounts. The engine and generator are mounted on rubber cylinders that absorb most of the engine vibration. This feature eliminates the tendency of the machine to “walk” which is common in engine powered equipment.
Reference 7 - Oil Drain Plug. Refer to your
Tecumseh engine manual for oil change recommendations.
Reference 8 - Choke Lever. Used during cold starts. Refer to the starting/stopping instructions and the Tecumseh engine manual for usage.
Reference 9 - Dipstick
Reference 10. Protective Frame. The frame protects to engine and generator from damage.
Reference 11 - Grounding Screw. Ground the generator via the grounding screw, to a copper pipe or rod that is driven into moist soil.
Reference 12 - 120V Receptacle. The generator
has a control panel with one duplex (two receptacles in a common housing) receptacle. The duplex is a 120 volt (V) 20 amp (A) straight blade receptacle, National Electrical Manufacturer’s Association (NEMA) number
Reference 13 - Circuit Breakers. This portable
single phase generator has two, 17 amp (A) push to reset circuit breakers to protect against electrical overloads.
Reference 14 - 240V Receptacle. This device is
a 240V 20A NEMA
ALWAYS use grounded male plugs. The neutral line of the generator is mechanically grounded to the frame. Matching NEMA male plugs must always be used.
Reference 15 - Generator Head. The electricity producing part of the generator.
Reference 16 – Warning Instructions. Reference 17 - Gas Tank. Always allow room
for gasoline expansion by not filling the gas tank completely full.
4
INTRODUCTION
Before starting your generator, thoroughly study the instructions and cautions in this manual to assure you are fully acquainted with the operation of all components of this generator. Proper preparation, operation and maintenance will result in operator safety, best performance and long life of the generator. For detailed engine operation and maintenance always refer to the Tecumseh engine owner’s manual furnished with the generator (Tecumseh refers to the 8 HP engine as a HM80).
NorthStar is constantly improving its products. The specifications outlined herein are subject to change without prior notice or obligation. The purchaser and/or user shall assume liability of any modification and/or alterations on this equipment from original design and manufacture.
Before using, the user shall determine the suitability of this product for its intended use and assumes liability therein.
ANSI SAFETY DEFINITIONS
DANGER indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. This signal word is to be limited to the most extreme situations.
WARNING indicates a potentially hazardous situation which, if not avoided, could result in a death or serious injury.
CAUTION indicates a potentially hazardous situation, which if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices.
RULES FOR SAFE OPERATIONS
Safety precautions are essential when operating this generator. Respectful and cautious operation will considerably lessen the possibilities of a personal injury. This manual will warn of specific personal injury potential, and these will be designated by the symbol:
WARNING This generator is equipped with a grounding post, located on the control panel for your protection. Always complete the grounding path from the generator to a copper pipe/rod that is driven into moist earth, to prevent electrical shock.
ALWAYS use electrical cords that are in good condition. Worn, bare, frayed or otherwise damaged cords can cause electric shock.
