WindChaser Products PACRWC Safety Instructions, Learn Intelligent AIR Conditioning

SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING THE AIR CONDITIONER

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1)Do not damage the power cord.

2)Never lay the unit down while it is off or working.

3)Always keep it in an upright position to avoid any damage to the cooling system.

4)Operate this unit in an ambient temperature of 90oF or lower.

5)Be sure that the air inlets and outlets are not blocked or covered up.

6)Never place anything on top of the unit and do not cover it with any kind of cloth while it is plugged in or in-use.

7)Your air conditioner has been designed to be used only in a house, office and similar conditions and it should not be used for any other purpose.

8)Never connect the unit to a defective outlet.

9)This unit needs at least 12Amps of electricity to start it’s compressor. Plug the unit into a properly grounded dedicated 15Amp or greater circuit. Check your breaker box to determine which circuit the outlet is on.

10)Make sure that the unit is correctly connected before turning on the unit’s power.

11)Never unplug the air conditioner while it is working. This could damage the electronic circuits.

12)To avoid tripping the circuit, DO NOT USE AN EXTENSION CORD FOR THIS UNIT.

13)To turn on your unit, always use the switch on the control panel.

14)Do not bend or crush the warm air exhaust hose.

15)It is dangerous to modify or to change the characteristics of the unit.

16)Prevent children from climbing on the unit.

17)Do not place the air conditioner near curtains (minimum distance 1.5 ft.).

18)Do not place the power cord under a carpet.

19)Never install the unit in direct sunshine or in the rain.

20)Keep the area around the warm air outlet sufficiently clean and make sure that it is not congested.

21)For any repairs, refer directly to our customer service department. Repairs carried out by unqualified people may cause damage or may even be dangerous

and void the warranty.

Any damage resulting from failure to comply with these instructions is excluded from the warranty.

SAVE THESE INSTRUCTIONS

LEARN INTELLIGENT AIR

CONDITIONING

This Portable Air Conditioner is electronically controlled, which allows precise programming to adjust the room tem- perature. This unit is a small appliance that adjusts the temperature and humidity in a room. It’s flexibility makes it easy to use in different applications and in various rooms. This unit is designed for use in a home, office and comput- er type room. This air conditioner allows you to control the 4 factors that determine optimal comfort in a room.

•Humidity Rate: the humidity in a room also causes a sensation of stifling heat in the summer. Your air conditioner not only cools down the temperature, but dehumidifies the air as well.

•Heater: The air conditioner will function as a heater, releasing warm air into the room without use of hose extensions.

•Temperature: the main function of an air conditioner is to draw hot air out of the room.

•Airflow: The air conditioner regulates the airflow, allowing the flow to be directed and ensuring optimal air circulation

•The unit will not instantaneously cool down the room once it is turned on. It will take the unit some time to gradually cool down the room.

•Ion Generator: Cleans and freshens the air. Produces Negative Ions For Clean and A Healthy Environment

*Note: Avoid being directly in front of the cold airflow and do not direct it onto people.

IMPORTANT INSTRUCTIONS

Do not install and use your air conditioner before completely reading these instructions. This will help you optimize the operation of your air conditioner.

The following advice and instructions should be followed closely:

BEFORE OPERATING THE UNIT, BE SURE THE DRAIN PIPE IS CAPPED WITH THE DRAIN PLUG.

1.Your unit must always be used in an upright position because it contains a cooling agent.

2.After unpacking, place the unit upright to allow the cooling agent to stabilize, and wait 3 hours before use.

3.When used for the first time, and every time it is turned on, it takes your unit up to 3 minutes to be

operational.

Failure to comply with these instructions may damage the unit and would invalidate the WINDCHASER guarantee.

TROUBLESHOOTING GUIDE

When the air conditioner does not work, it is sometimes a minor problem which the user can handle. Before calling customer service, please check the following points to see if they solve your problem. Additional troubleshooting tips may be found on our website at: www.windchaserproducts.com.

Problem	Probable Causes	Solutions
The air conditioner / dehumidifier	1) Check LCDI plug to be certain it is in an	1)	Press the test button, then firmly press
doesn’t work.	engaged position		the reset button.
	2) Plug not properly inserted into wall	2)	Plug the appliance in properly.
	outlet.
	3) Insufficient amount of amperage to	3)	Check circuit breaker box for
	start unit.		15-20amp circuit availability.
	4) Water tank is full / alarm light	4)	Drain Unit.
	illuminated.
The air conditioner cuts off.	1) Exhaust hose too long, run	1)	Exhaust hose can only be
	incorrectly or kinked.		extended using max. 5’ of 4”
	2) Unit too close to wall		PVC pipe or flex ducting for a total
			exhaust length of 10’.
	or object.	2)	Unit should be at least 1 ½’
	3) Ceiling or basement does		away from walls and objects
	not have ample ventilation.	3)	Unit will overheat if the exhaust
	4) The “timer off” function		cannot fully vent.
	has been activated.	4)	Push the power button to turn unit on.
	5) Room temperature is not between	5)	Turn unit back on when room
	61o-90oF.		temperature is between 61o-90oF.
The WATER FULL LED indicator	The condensate tank is full and	Drain unit from the drain plug at the back
light flashes.	the unit cannot drain. This safety feature	of the unit.
	turns off the unit to protect the unit and
	prevent the condensate tank from
	overflowing.
The LED display shows the unit is set, but	The unit’s “timer on” feature is	1)	This is normal.
the unit is not running.	activated.	2)	Push the Power button to turn the unit
		on and deactivate the “timer on” feature.
E1: Error code	Room temperature sensor is damaged	Need to change the temperature sensor
		(contact WindChaser Products customer
		service)
E2: Error code	Room coil sensor is damaged	Need to change the room coil sensor
		(contact WindChaser Products customer
		service)
E3: Error code	Anti-freezing protection (compressor)	Contact WindChaser Products customer
		service
E4: Error code	System protection is abnormal (R22 has	Contact WindChaser Products customer
	leaked)	service

2 11