ENGLISH 6
ASSEMBLY (Continued)
6. Attach the Wheels to the Base Support by using two of the #4 Wheel Rods.
Slide a #5 Lock Washer onto a Wheel Rod, and then p ush the Wheel Rod
through the holes in the Base Support. Make sure to place the two #6 Flat
Washers between the Base Support and the Wheels. R epeat on the other
wheel. Finally, place the two #7 Wheel Rod Caps on t he outside of the screws
for cosmetic purposes (as shown below):
7. Place the Main Unit onto the Storage Compartment so that the two side holes
match up. Connect the Main Unit to the Storage Compart ment using the two
included Lock Screws (D) as shown below:
8. Place the Clear Plastic Bow l into the top of the Main Unit and firmly secure the lid
into the bowl. Make sure that the end of the lid with t he two tabs is properly
placed into the corresponding holes and the lid snap sh uts. Please note that the
ice will not shave unless the lid is properly secured. Nev er force it down.
You are now ready to use your SNOW CONE CART™!
Helpful Hint: Use the black plastic adjusters on the botto m of the feet to properly level.