Numark Industries 9-Aug quick start

12.KEY- Used for various key control.

13.-,+ - Works as pitch bend and controls key and pitch functions.

14.PITCH SLIDER- Controls the overall speed of the music.

15.PITCH RANGE LED- Indicates current pitch range of the pitch slider

16.EFFECT BUTTON- Used to determine desired effect.

17.EFFECT HOLD- Used to set effects to an alternate position

18.LOOP IN- Used to set stutter and loop in points.

19.LOOP OUT - Used to set loop out points and release the loop.

20.RELOOP/STUTTER- Used for repeated play (stutter) from the loop in point, repeating a previously set, and hot start.

21.RELAY- Used for setting Alternating play start between attached units.

22.BEAT SYNC with MARCHING BAR GRAPH- Tracks the beats and measure position of music

23.CD Illumination Light (unit front) – lights up the CD drawer and CD when open.

24.CD Drawer (Unit Front) – Place your CDs you wish to play in here. This unit is designed to play commercially available CD and properly burned and finalized CDR. Due to variances on the specification of certain CD burners and CDs some discs home made CDs may not play properly.

25

28 29 30 26 27

25.Power Switch- Turn on and turn off the machine with this button. The unit should always be shut down with this button first before any external power is removed. Typically it is recommended that the CD player is powered on before amplifiers and off after amplifiers to avoid an audio spike to be sent through your equipment.

26.IEC Power Plug Connector - Plug your supplied power cord in here.

27.Voltage Selector - Set this switch to the voltage for your location.

28.RCA Audio Connectors - Connect your CD player to your mixer from this line level output.

29.Relay Connector- If you wish to use the relay function plug in your 3.5mm stereo control cables into here and then into your other unit. The cable must be a stereo style plug for the units to work properly

30.Remote Start Connector – Use this connector to plug into your fader-start compatible mixer or remote switch. This function is always active.

a.To use fader-start, connect a 1/8” mono minijack cable to a fader-start compatible mixer. Every time you move the crossfader on the mixer over to the side that the unit is on, it will automatically start playing. When you move the fader away from that side, the unit will stop. Moving the fader back to the unit side will start play again.

b.Foot switches can also be attached to this jack for creative mixing techniques and can be found in most music shops. Connector plugs are often ¼” and an adapter to 1/8” will be needed for connection. There are also two types of footswitches that will work with this connector. The first is a typical, on/off pushbutton switch and are generally used for switching channels on guitar amps. The second switch is a momentary footswitch and is usually used for keyboard sustain pedals.