Problem |
| Cause? | Solution | ||
|
|
|
|
|
|
Mixer does not turn on. |
| Disconnected Power Cord? |
| Connect Power Cord. | |
|
| ||||
|
|
|
|
|
|
The sound level is very low. |
| The Turntable is not connected to a |
| Connect the turntable to the input | |
|
| device with a PHONO preamp. |
| labeled PHONO, not the LINE. | |
|
|
|
|
|
|
The sound is on one side only. |
| The RCA audio cord is |
| Properly secure the RCA cable to | |
|
| disconnected. |
| the mixer. | |
|
| The RCA audio cord is damaged. |
| If the RCA cord is frequently | |
|
|
|
| connected and disconnected, it | |
|
|
|
| may have become damaged and | |
|
|
|
| needs to be replaced. | |
|
|
|
|
|
|
The output sound is very distorted. |
| The Trim Control is set too high. |
| Reduce the Trim level until the | |
|
|
|
| sound is loud and clear. Then use | |
|
|
|
| the Input fader to adjust the | |
|
|
|
| volume. | |
|
|
|
|
|
|
The Output sound exhibits |
| The Turntable Grounding wires are |
| Connect the Turntable Ground | |
excessive hum or buzzing. |
| not connected. |
| wires to their respective Grounding | |
|
|
|
| Lug on all equipment (mixer, etc.) | |
|
|
|
|
|
|
There is no sound, but everything |
| The Input Selector is not switched |
| Switch the Input Selector so that | |
is connected. |
| to the correct source. |
| the connected source is engaged. | |
|
|
|
|
|
|
NOTE:
Static electricity and/or other external interference may cause this unit to malfunction. To reset the unit to its normal condition, turn the power off and then on again. If the problem continues to persist, refer to the connected component's troubleshooting guides. If the problem is not resolved after checking these items, contact the nearest authorized Numark dealer.
TROUBLE SHOOTING | PAGE 10 |