Numark Industries TT-100 owner manual Diagram And Parts Description, PRO TT-2Turntable

PRO TT-2 Turntable

DIAGRAM AND PARTS DESCRIPTION

9		10
8		11
7		12
6		13
5		14
4		15
1	17	16

2

3

To fully appreciate the features of the TT-100, please read this entire manual before you begin operation. The TT-100 should be placed on a level sturdy surface. Keep in mind that there are a few features you may never have seen before on a turntable of this type that you will need to read about to use properly.

Start by removing all parts from the package and place on a level surface. Carefully check all packing material for hidden parts. Use the contents guide for reference. Do not discard any packing materials!

1.Power Dial

On - Rotate Right

Off - Rotate Left

2.START/STOP - Pressing once engages high torque motor; pressing again engages brake.

3.Platter Revolution Speed Buttons

33rpm - Press 33 45rpm - Press 45 78rpm - Press 33 and 45

4.Strobe Light - Pulses a beam of light at the Strobe Dots. The large dots will seem not to move when pitch is 0%.

5.Strobe Dots - Four rows of dots that indicate various stages in pitch adjust.

-3.3% - outer row

0% - large dots

+3.3% - next row

+6% - inner row

6.Platter - Place this on the Center Spindle.

7.Center Spindle - Keeps platter and records centered. Place the supplied slipmat on the Center Spindle now.

8.45 Adapter - Place on Center Spindle for playing 7” records with large center holes.

9.Forward/Reverse Buttons - Determine the direction the platter will spin.

10.Lid Hinge Holder - Place the bottom tabs of your lid hinges in here after you finish assembly.

11.Extra Stylus Holder - Place an extra headshell here.

12.Tone Arm Assembly - Explained in tonearm section

13.Pitch Adjust - Use this to change the speed of the platter when quartz lock is inactive.

14.Pitch Percent Indication – Shows the amount of pitch change possible

15.Quartz Lock

On - will hold the revolution speed to 0% Off - will allow use of the Pitch Adjust

HOLD DOWN- to alternate from 10% to 20% Pitch

16.Target Light - Press the button to the right and a light will pop up directed at the stylus position.

17.Voltage Selector - With unit unplugged set the desired voltage for your location using a screw driver.

- The Leader in DJ Technology

©2000Industries - 6 - http://www.numark.com