MODEL 761WHNT
Page
INSTALL THE HOUSING (continued)
Existing Construction
CONNECT THE WIRING
SCHEMATIC WIRING DIAGRAM
L I G H T |
|
| R E D B L U L I G H T W H T |
S W I T C H |
|
| ( W H I T E ) |
V E N T | B L K | B L K |
| W H T | |
V E N T | |||||
S W I T C H | |||||
|
| ( B L A C K ) |
| ||
B L K |
|
|
| ||
|
|
|
|
L I N E W H TW H T
I N G R DG R D
S W I T C H B O XU N I T
4.Place housing in opening so that its bottom edge is flush with finished ceiling. Nail to joist through keyhole on both sides. To ensure a
DUAL CONTROL
(purchase separately)
LIGHT
FAN
BLACK | RED | WHITE |
RECEPTACLE | ||
WHITE | GROUND | (LIGHT) |
BLUE | (bare) | BLACK |
| ||
|
| RECEPTACLE |
|
| (FAN) |
WIRING
PLATE
ADDITIONAL
MOUNTING
HOLES
5.Additional mounting holes are provided for installations where access from above is inconvenient or not possible. Nail or screw housing directly to joists or framing.
INSTALL THE DUCTWORK
flush
NOTE: The duct connec- tor has a
“open” approx. 1” when duct connector is attached to housing. This design permits insulation to be in direct contact with fan/ light housing per UL (Underwriters Laboratories) standards. The slightest backdraft, however, will close the damper flap, preventing air from entering unit or finished space.
1.Snap the damper/duct connector onto housing. Make sure that tabs on the connector lock into slots in housing.
Top of damper/duct connector should be flush with top of housing.
2.Connect 4” round duct to damper/duct connector and extend duct to outside through a roof or wall cap. Check damper to make sure that it opens freely. Tape all duct connections to make them secure and air tight.
1. Wire unit following diagram above. Run electrical cable as direct as possible to unit. Do not
allow cable to touch sides or top of unit after installation is complete.
ATTACH THE GRILLE PAN AND GLASS SHADE
1. Locate the grille pan
over the fan housing | GRILLE | GRILLE | |
and connect the wiring | |||
PAN | SCREW | ||
harness plug into white | |||
|
| ||
receptacle in the fan |
|
| |
housing. |
|
| |
2. Insert rod through center | WASHER | COLLAR | |
hole of grille pan. Use | ROD | ||
washer between collar |
| ||
|
| ||
on rod and pan. |
|
|
3. Thread rod onto grille screw in housing, until pan is tight against ceiling.
4. Install bulbs. Use
5. Place washers and glass shade over mounting rod and align shade onto grille pan. Secure glass shade to grille pan with finial cap and finial nut as shown.
6. Restore electrical power and check operation of the unit.
