WIRING
1.Run 120vAC housing wire to fan location.
2.Refer to figure 3. Remove two (2) screws in switch box and carefully pull off box cover.
3.Remove one of the circular knockouts in the bottom of switch box.
4.Pull supply wires through knockout hole.
5.Connect supply wires to fan wires as follows: black
to black; white to white; green to green grounding screw.
6.Replace switch box cover and secure with two (2) screws.
COMPLETING ASSEMBLY
1.Remount motor and fan assembly; secure by tightening screws into small end of keyhole slots. Plug the fan motor wire into
2.Mount grilles and secure with two (2) screws.
3.Place control knob onto switch shaft.
EXTENSION | GRILLE |
|
BRACKET |
|
|
GRILLE |
|
|
| AIR FLOW |
|
| CONTROL KNOB | FIGURE 2 |
| BLACK |
|
|
| GREEN |
|
| SWITCH |
BOX |
| BOX |
|
| |
CONNECTOR |
|
|
AIR FLOW |
OUTER SLEEVE |
ON/OFF SWITCH |
FIGURE 4 |
BOX COVER
| 120vAC |
WHITE | HOUSE WIRE |
SOCKET
FIGURE 3
