09Additional information
Problem | Remedy |
Broadcast stations cannot | • Connect an outdoor antenna (refer to page 25). |
be selected automatically. |
|
|
|
No sound from surround or | • Connect the speakers properly (refer to page 18). |
center speakers. | • Refer to Speaker setting on page 38 to check the speaker settings. |
| • Refer to Channel level on page 39 to check the speaker levels. |
| |
No sound from subwoofer. • Make sure the subwoofer is switched on. | |
| • If the subwoofer has a volume knob, make sure it’s turned up. |
| • The Dolby Digital or DTS source you are listening to may not have an |
| LFE channel. |
| • Switch the subwoofer setting in Speaker setting on page 38 to YES or |
| PLUS. |
| • Switch the LFEATT (LFE Attenuate) on page 34 to LFEATT 0 or LFEATT 5. |
|
|
The PHASE CONTROL | • If applicable, check that the lowpass filter switch on your subwoofer is |
feature doesn’t seem to | off, or the lowpass cutoff is set to the highest frequency setting. If there is |
have an audible effect. | a PHASE setting on your subwoofer, set it to 0º (or depending on the |
| subwoofer, the setting where you think it has the best overall effect on the |
| sound). |
| • Make sure the speaker distance setting is correct for all speakers (see |
| Speaker distance on page 39). |
|
|
Noise during playback of a | • Move the cassette deck further from your receiver, until the noise |
cassette deck. | disappears. |
|
|
No sound is output or a | • Set the digital volume level of the player to full, or to the neutral |
noise is output when | position. |
software with DTS is played | • Make sure the player’s settings are correct and/or the DTS signal out is |
back. | on. Refer to the instruction manual supplied with the DVD player. |
| • Set the input signal type to C1/O1/O2 (DIGITAL) (see Choosing the |
| input signal on page 36). |
|
|
During a playback search, | • This is not a malfunction, but be sure to turn the volume down to |
noise is output from a DTS | prevent the output of loud noise from your speakers. |
compatible CD player. |
|
|
|
Everything seems to be set | • Check that the positive/negative speaker terminals on the receiver are |
up correctly, but the | matched with the corresponding terminals on the speakers (see |
playback sound is odd. | Connecting the speakers on page 18). |
|
|
Can’t operate the remote | • Replace the batteries (refer to page 10). |
control. | • Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel |
| (refer to page 7). |
| • Remove the obstacle or operate from another position. |
| • Avoid exposing the remote sensor on the front panel to direct light. |
|
|
The display is dark or off. | • Press DIMMER on the remote repeatedly to return to the default. |
|
|
48
En
