Controls and displays | 02 |
TEST TONE
Outputs the test tones on each channel. Use the / buttons to select the channel and use the / buttons to adjust the level on each channel. Pressing TEST TONE again exits the test tone mode.
SB CH
Press to select ON, AUTO, OFF the surround back channel.
CH SELECT
Press repeatedly to select a channel, then use LEV +/– to adjust the level (page 39).
LEV +/–
Use to adjust the channel levels.
MIDNIGHT
Switches to Midnight or Loudness listening (page 33).
SPEAKERS
Use to change the speaker system on or off. When the SP OFF is selected, no sound is output from the speakers connected to this receiver.
DIMMER
Dims or brightens the display. The brightness can be controlled in four steps.
12 SOURCE
Turns on or off the power of the Pioneer DVD/ DVR units when BD, DVD, DVR or CD is selected using the MULTI CONTROL buttons.
13 TV CONTROL buttons
These buttons can control only be used with Pioneer flat panel TVs.
Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
DTV/TV*
Switches between the DTV and analog TV input modes for Pioneer flat panel TVs.
14MASTER VOLUME +/– Use to set the listening volume.
15MUTE
Mutes/unmutes the sound.
16 DISP
Switches the display of this unit. The listening mode, sound volume, Pre Out setting or input name can be checked by selecting an input source.1
17 SHIFT
Press to access the ‘boxed’ commands (above the buttons) on the remote. These buttons are marked with an asterisk (* ) in this section.
English Deutsch Français Italiano Nederlands Español
Note
1 The Pre Out setting may or may not be displayed, depending on the input source you have selected.
15
En