Additional information
Chapter 9:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.
•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.
Problem | Remedy |
The power does not turn | • Disconnect the power plug from the outlet, and insert again. |
on. | • Make sure there are no loose strands of speaker wire touching the rear |
| panel. This could cause the receiver to shut off automatically. |
| • If the power shuts off automatically, take the unit to your nearest |
| Pioneer authorized service center or your dealer for servicing. |
No sound is output when a • Make sure the component is connected correctly (refer to Connecting
function is selected. | your equipment on page 16). |
| • Press MUTE on the remote control to turn muting off. |
| • Press SIGNAL SEL to select the proper input signal (see Choosing the |
| input signal on page 36). |
No image is output when a • Make sure the component is connected correctly (refer to Connecting
function is selected. | your equipment on page 16). |
| • Select the correct component (use the MULTI CONTROL buttons). |
| • Check The Input Assign menu on page 40 to make sure you’re assigned |
| the correct input. |
| • The video input selected on the TV monitor is incorrect. Refer to the |
| instruction manual supplied with the TV. |
|
|
Considerable noise in radio | • Connect the antenna (page 25) and adjust the position for best |
broadcasts. | reception. |
| • Route any loose cables away from the antenna terminals and wires. |
| • Fully extend the FM wire antenna, position for best reception, and |
| secure to a wall (or connect an outdoor FM antenna). |
| • Connect an additional internal or external AM antenna (page 25). |
| • Turn off equipment causing interference or move it away from the |
| receiver (or move antennas farther away from equipment causing noise). |
|
|
09
English Français Español
47
En
