Additional information
Important information regarding the HDMI connection
There are cases where you may not be able to route HDMI signals through this receiver (this depends on the HDMI equipped component you are
If you aren’t receiving HDMI signals properly through this receiver (from your component), please try the following configuration when connecting up.
Configuration1
Connect your
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver into standby.
2While holding down the BAND button, press and hold the STANDBY/ON button for about two seconds.
3When you see RESET? appear in the display, press AUTO SURROUND/STREAM DIRECT.
OK? shows in the display.
4Press STEREO/ALC to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
09
English Français Español
Note
1• If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.
•Depending on the component, audio output may be limited to the number of channels available from the connected display unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).
•If you want to switch the input source, you’ll have to switch functions on both the receiver and your display unit.
•Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the display every time you switch input sources.
51
En
