2. HOW TO USE POWER BRUSH/WAND (continued)
2.6 ELECTRONIC CIRCUIT BREAKER
The power brush is equipped with an electronic circuit breaker that protects the motor and the belt if a too large object is picked up accidentally.
If the power brush stops while vacuuming, turn the power unit off using handle. Release the power brush from the wand and turn it over to see if there is an obstruction. When brush roll jam has been cleared, press the reset button (H) and connect the power brush back to the wand. Finally, turn the power unit/power brush back on. If it fails to restart or continues to trip without any apparent reason, the power brush must be serviced by an authorized service center.
H |
3. CLEANING & STORAGE
!WARNING
Disconnect electrical supply before servicing or cleaning the unit. Failure to do so can result in electrical shock or personal injury from cleaner suddenly starting.
3.1 CLEANING BRUSH ROLL
In order to keep high cleaning efficiency and to prevent damage to your vacuum cleaner, the brush roll must be cleaned every time the belt is changed.
The brush roll must also be cleaned according to the following schedule:
VACUUM CLEANER USE | CLEAN BRUSH ROLL |
Heavy (used daily) | Every week |
Moderate | Every month |
Light (1 time per week) | Every 2 months |
Check and remove hair, string and lint
3.2 CLEANING HOUSING
To keep the power brush housing clean, it can be wiped with a damp cloth and a mild soap solution, then thoroughly dried. Never use any type of chemical as they can damage the housing.
3.3 STORAGE
1.Ensure that hose and power cord are disconnected from wall inlet before unplugging power brush.
2.Disconnect hose handle from wand.
3.Always keep hose neatly coiled when not in use.
4.When not in use, the power brush should be stored in a clean, dry place.
-5 -
