NuTone NP60000 Select Blower Option And Install Ductwork, Roof cap 10” round duct In-lineblower

1. SELECT BLOWER OPTION AND INSTALL DUCTWORK

Either an interior or exterior blower or in-line blower may be used with this hood. The NuTone Premier 60000 Series must be installed with blower models RM325H, RM326H, HLB3, HLB6, HLB9, HLB11, 331H, 332H, 335 or 336 only. Other blowers cannot be substituted. (Blowers sold separately).

NOTE: In addition to the blower models listed above, this hood is also compatible with older internal versions 325H and 326H. However, discard the installation instructions included with those blowers and contact our technical support to obtain replacement instruction.

Plan where and how the ductwork will be installed.

If installing in-line blower, refer to instructions packed with in-line blower and follow steps 1 up to 6, 9, 10, 11, 13 and up of this manual.

Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use 2” duct tape to seal duct joints.

ROOF CAP

7" (178 mm)

ROUND DUCT

ROOF CAP

10" (254 mm)

ROUND DUCT

DECORATIVE		12"
FLUE	(305 mm)
or SOFFIT

HOOD

24" TO 30" (609 to 762 mm)

ABOVE COOKING SURFACE

WALL CAP

7" (178 mm)

ROUND

ELBOW

DECORATIVE 12"	WALL CAP
FLUE (305 mm)
or SOFFIT
	4-1/2" x 18-1/2"
HOOD	to 10"
	(114 x 470 to
	254 mm) ROUND
	TRANSITION
	(see page 4)
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE

HH0024A

HH0025A

MODEL RM325H SINGLE BLOWER

TYPICAL DUCTWORK

EXTERIOR BLOWER
		10" (254 mm)
		ROUND DUCT
DECORATIVE	12"	10" (254 mm)
FLUE
or SOFFIT (305 mm)		ROUND ELBOW
		EXTERIOR
		BLOWER
HOOD		332KR
		ROUGH-IN KIT
		(see page 5)
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
HH0026A
MODEL 331H, 332H, 335 OR 336

EXTERIOR BLOWER TYPICAL DUCTWORK

MODEL RM326H DUAL BLOWER

TYPICAL DUCTWORK

Roof cap

10” round duct In-line blower

Wall

cap

Hood

24” minimum

above cooking

surface

HH0066A

MODEL HLB3, HLB6, HLB9 OR HLB11

IN-LINE BLOWER TYPICAL DUCTWORK

- 6 -